| Author | Forum: PowerVT Topic: PowerVT and change port |
| jrgeilo From: Albuquerque, NM USA Posts: 4 Member Since: 09/15/05 |
posted September 15, 2005 2:45 PM Can I change the standard port configuration? |
Tony Priest From: Utica, NY USA Posts: 8466 Member Since: 04/11/00 |
posted September 15, 2005 2:53 PM Yes. You can configure the COM ports in many different ways. |
| jrgeilo From: Albuquerque, NM USA Posts: 4 Member Since: 09/15/05 |
posted September 16, 2005 8:33 AM How would I change the listting port to like 226 and dest port to 23? |
| Tony Priest From: Utica, NY USA Posts: 8466 Member Since: 04/11/00 |
posted September 16, 2005 8:45 AM What is a "listting port?" Also, please make sure you are posting in the correct forum. This is for the PowerVT terminal emulator application, not one of our PowerTCP components. What is the exact name of the product that you own? |
| jrgeilo From: Albuquerque, NM USA Posts: 4 Member Since: 09/15/05 |
posted September 16, 2005 9:09 AM I have downloaded PowerVT for XP for 30 day Trial. I am using KEA! 340 now to connect up to my Open VMS system. I can within the old product set the telnet port to some thing other then 23. So i can tunnel that port through F-secure. The reason I am looking at your product is that the old KEA will not run on XP 64 bit, but your product will and I need a replacement. |
| Tony Priest From: Utica, NY USA Posts: 8466 Member Since: 04/11/00 |
posted September 16, 2005 9:23 AM Under Session Properties, there is a "Telnet" tab. That tab is the place where you set the address and port. |
| jrgeilo From: Albuquerque, NM USA Posts: 4 Member Since: 09/15/05 |
posted September 16, 2005 9:36 AM Thanks, I just throught that you had to select one of the options, not just type in the port number you need to use. |
| Reply | PowerVT Topics | Forums |
This site is powered by
PowerTCP WebServer for ActiveX
|